In looking ahead to Christmas at Sea 2021 and 2022 we are asking people to make Ditty bags. The bag becomes a part of the gift which seafarers can use.
Below is a pattern for you to use. Happy sewing and thank you for the support.
Ditty Bag Pattern
Getting Ready -- A Few Basics:
-
A finished ditty bag is 14 inches long by 12 inches wide, with a turned down
casing of 1 and 1/2 inches.
-
Add an additional 1 and 1/2 inches to the length dimension for the casing.
-
When you begin sewing the bag, use 1/2 inch seam allowances.
-
If you are able to fold the fabric to eliminate one side seam or the bottom
seam, be sure not to include that seam allowance when cutting.
Sewing Instructions:
-
With right sides together, sew the bottom seam and one side seam.
-
Working on the wrong side of the fabric on the unsewn side, measure up from the bottom seam line, marking in the side seam allowance at 13 inches and again at 14 inches.
-
Sew this side seam right sides together, leaving the 1 inch gap open.
-
Turn down the 1 and 1/2 inch top casing to the inside, and topstitch in place 1 inch from the top.
-
Turn bag right side out.
-
Thread a 1 yard long piece of cording through the casing. Knot cord ends.
For an Alternative Ending:
-
Turn down the top casing over the drawstring, pin the edge and sew down about 3/4″ from the top, enclosing the cord.
-
Turn inside out and knot the ends of the cord together.
Some Final Thoughts:
-
Suggested fabrics include medium weight flannel, cotton or denim.
-
Suggested cording should be a maximum of 1/4” in diameter. Please do not use embroidery floss, yarn or twine.
When completed please mail or drop off to:
The Mission to Seafarers
401 E. Waterfront Road
Vancouver,BC
V6A 4G9
(the end of Main St over the flyover and turn left and drive to the end and we are the big blue house.)
Tel: 604 253 4421